CRL Oil Rub Bronze Geneva Series Wall Mount Short Back Plate Hinge w/ 5 Deg. Pre-Set
The Geneva Series of professional hinges is able to accommodate 5/16 to 1/2 inch (8 to 12 millimeter) glass. A variety of six styles, including Wall Mount and Glass-to-Glass types, gives design flexibility. The cut-out with the short Back Plate allows glass to be closer to the wall. They are made of solid brass with all moving parts (pins and springs) in stainless steel. Geneva Hinges are self-centering, and contain a Reversible 5 Degree Pivot Pin. In addition, Custom Pivot Pins are available to accommodate "off angle" installations. Standard Reversible Pivot Pin: Each Geneva Hinge contains a Reversible Pivot Pin. One side of the Pin is marked 90 degrees. The opposite side is marked 85 degrees. Standard Geneva Hinges come with the 90 degrees side activated. Offset Models come with the Pin pre-set to 85 degrees (5 degree tighter closure into shower interior). The Pin can be rotated (not flipped upside down) to activate the other side. Custom Pivot Pin: Custom Pivot Pins (Cat. No. GENP1N) are available to accommodate "off-angle" installations. If the Standard 5 Degree Reversible Pivot Pin contained in the hinge does not assist in closing the door to the position desired, you may specify the angle needed for a Custom Pivot Pin (up to 45 degree). If using the Custom Pivot Pin, contact our Technical Sales Department. Your glass sizes and the aesthetics of the enclosure may be affected by the use of the Custom Pivot Pin. Using two hinges with 5/16 to 1/2 inch glass (8 to 12 millimeters) the hinge will hold up to 80 pounds (36 kilograms) with a maximum width of 28 inches (711 millimeters). Using three hinges with 5/16 to 1/2 inch glass (8 to 12 millimeters) the hinge will hold up to 120 pounds (54 kilograms) with a maximum width of 32 inches (813 millimeters). Specifications:
Glass Thickness: 5/16 to 1/2 inch (8 to 12 mm) Tempered Safety Glass Construction: Solid Brass Hinge Swings: 90 Degrees Inwards and Outwards Closing Type: Self-Centering when within 15 Degrees of closed position Cut-Out Required Includes: One Hinge, Gaskets, Screws and Template
Custom finishes are available on request. Contact the CRL Technical Sales Shower Door Department at (800) 421-6144, Ext. 7740, or e-mail to CRL Technical Sales.